Sub-Zero Wine Storage Error Code 10 0 00
10 0 00 on Designer (formerly Integrated) wine storage points to an unprogrammed replacement control board or an open thermistor on a DEFL-configured model.
Sub-Zero ID-30F freezer drawers — model notes, common issues and what to have ready before booking.
Start with the basics before booking a visit for a 30-inch Sub-Zero ID-30F. Look at the drawer gasket for food debris or a gap, and confirm that the freezer setting has not been changed by accident. Listen for a compressor or fan that has become louder, and check whether there is any water near the base of the cabinet. Frost that forms on the back or the drawer rails is worth photographing, since a picture shows the defrost pattern better than a description alone. Do not remove panels or try to reach the sealed system yourself. Households in the Miami, New York, Houston, Los Angeles and San Diego metro areas can then add the ID-30F and these findings to the booking form.
| Model | ID-30F |
|---|---|
| Appliance | 30-inch freezer drawers |
| Common symptoms | frost on back or drawer rails, louder compressor or fan, water near the cabinet base, drawer gasket debris or gap |
| What you can check | Look at the drawer gasket for food debris or a gap, and confirm the freezer setting was not changed by accident. Photograph frost and check for water near the base. |
| When to call a technician | Do not remove panels or reach for the sealed system yourself. If frost, noise or water continues, a technician is the right next step. |
ID-30F is a Sub-Zero 30″ freezer drawers. The model number is printed on the rating label, usually on a side wall or the ceiling inside the fresh-food section, or behind the base grille; match it letter for letter before booking.
Check the rating label on a side wall or the ceiling inside the fresh-food section, or behind the base grille. Use the full number, including any letters at the end.
Yes. We book in-home visits for this model in the Miami, New York, Houston, Los Angeles and San Diego metro areas. Add the model number and the symptom to the booking form.
Note how long the temperature has been off and whether the freezer side is affected too.
10 0 00 on Designer (formerly Integrated) wine storage points to an unprogrammed replacement control board or an open thermistor on a DEFL-configured model.
Code 15 4 00 reports the defrost relay stuck open on Designer, Classic BI and Classic CL units.
On Classic (BI) and Designer units, 20 2 00 reports a defrost bi-metal stuck open.
Code 30 8 05 reports no ice maker fill signal on Classic (BI) and a missing water valve in signal on Designer units.
35 3 33 reports a zone 3 fan speed set too low. A breaker reset and retest is the owner step.
Code 40 1 00 flags a Zone 1 stepper current fault on Designer wine storage and Designer (Integrated) units.
45 1 01 flags a short in the refrigerator light circuit on Classic (BI) and Classic (CL) units. Try a 30-second breaker reset.
Code 90 5 80 means no keypad communications on Classic (formerly BI) Series units; reset the breaker for 30 seconds.
Note how long the temperature has been off and whether the freezer side is affected too.
Model-information disclaimer. Confirm your exact model number and specifications with your appliance documentation before booking a repair. Model pages are for identification and compatibility reference.
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Fields marked with * are required.