10 0 00 on Designer (formerly Integrated) wine storage points to an unprogrammed replacement control board or an open thermistor on a DEFL-configured model.
Model compatibility: Sub-Zero reused visible code strings across series and model years, so 10 0 00 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
Code 10 0 00 means the control board was replaced but not programmed, or a thermistor is open on a unit programmed for DEFL configuration.
Two possible readings
The Designer (formerly Integrated) Series lists 10 0 00 for either of these:
At a glance
Code
10 0 00
What it means
Code 10 0 00 means the control board was replaced but not programmed, or a thermistor is open on a unit programmed for DEFL configuration.
What you can check
Switch the unit's breaker off for 30 seconds, switch it on, and retest operation.
When to call a technician
If a control board was recently swapped, tell the technician. If the code persists after the reset, book a service visit for the wine unit.
the control board has been replaced but has not been programmed;
a thermistor is open on a unit whose model is programmed for the DEFL configuration.
Reset
Switch the unit’s breaker off for 30 seconds, switch it on, retest operation.
Next in the list
Codes starting 10 1 describe zone 1 thermistors: Code 10 1 00 is a cabinet thermistor open, and Code 10 1 10 is an evaporator thermistor open.
Service for Designer wine storage in Miami, New York, Houston, Los Angeles and San Diego
If a board was recently swapped, tell the technician. Call (844) 972-4767 for Sub-Zero wine storage service in the Miami, New York, Houston, Los Angeles and San Diego metro areas, or start with the wine storage repair page. Bring the model, serial number and the code.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your Sub-Zero appliance?
Book a specialist visit for a clear estimate and approval before any repair.